[mach9]

Application Instructions.
Used on the following models.
1970 TNT 292, 340, 399, 640, 771
Product will also work on most clothing fabrics, for shirts, hats or jackets etc.

These are heat pressed on just like the rubberized lettering you see on sports jersys.
Pressed on with a hot iron set at over 300 degees.


1. Cut a round circle in some thin cardboard (from a gift box) just a little bigger than the decal. This is so you don't heat up the seat too much with a big iron.


2. Simply peel off the paper backing to expose the underside of the heat patch.


3. Place the patch in your prefferd location. Use the square portion corners of the sticky transfer tape to hold the decal in place over the cardboard.


4. Press hard and hold for 10 seconds. Check the bond, apply more heat if required.
Not all irons are created equal and the heat setting may have fluctuations.
Use your judgment, as the amount of pressure you apply and the heat will vary.
When you are pleased with the bond. Peel off the warm top transfer tape slowly.


5. Enjoy
_________________
Mark (mach9)
Shiny side up! Rubber side down!
To visit the store...
www.doodecals.com