Author |
Message |
mr.modified 1000 rpm
Joined: 28 Dec 2011 Posts: 2
|
Posted: Wed Dec 28, 2011 5:18 pm Post subject: 1967 olympique 250 |
|
|
I recently purchaced a 67 olympique and plan on restoring in time for next season. I haven't started disassembly just yet, but I'm curious to know how to separate the track drive shaft from the chain case or remove/install the chain. There must be a gear on the shaft for the chain of course and I would assume you would have to remove this before sliding out the shaft. Since the case is welded together, I was confused about how it's put together. Also how would you put a drive chain in with the chain case still in the sled. I can see where it would be a problem for the chain to go around the bottom sprocket then up to the top against gravity... If anyones around, thanks for responding. |
|
Back to top |
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Blocked registrations / posts: 11819 / 0
|
|